Bring your machine setup ready to run on the dyno.
A. Make sure it is full of the fuel you want to run
B. The air filter is clean
C. Oil and coolant are fresh and at the proper level
D. Fresh spark plugs are always recommended
Wash/clean your machine. If something is completely covered in mud and filth, we will not dyno it until it has been cleaned. Thus a cleaning/washing charge may apply.
REMOVE SPARK ARRESTORS – The dyno uses a probe in the exhaust to record air/fuel, to do so any spark arrestors or quiet cores will need removed.
If it is a new or rebuilt engine, make sure it has the proper heat cycles performed so we can start tuning.
If you have paddles or wheels spacers please remove them. Maximum width is 68”